Wilhelmsen UNITOR UWW-301, Instruction Manual, Page: 17 / 38

UWW-301 TP
Page 17 of 38 Revision: 1.0/June-/2020
4.7 MIG/MAG WELDING
S1
This button serves to select the following welding mode: MIG/MAG
4.7.1 PARAMETERS SETTING: MIG/MAG WELDING VOLTAGE
POT3 Using the potentiometer, edit the value of the parameter.
The value is saved automatically.
PARAMETER MIN DEFAULT MAX
MIG/MAG WELDING
VOLTAGE
10.0 V - 40.0 V
4.7.2 PARAMETERS SETTING: WIRE FEED RATE
POT2 Using the potentiometer, edit the value of the parameter.
The value is saved automatically.
PARAMETER MIN DEFAULT MAX
WIRE FEED RATE 1.0 m/min 20.0 m/min
4.7.3 PARAMETERS SETTING: INDUCTANCE SETTING
POT1 Using the potentiometer, edit the value of the parameter.
4.7.4 PARAMETERS SETTING: POST GAS TIME
Keep the lever raised (SEL1) for 3 seconds to access the menu.
ACRONYM PARAMETER MIN DEFAULT MAX
Po.G. POST GAS TIME 0.0 s 3.0 s 10.0 s
4.7.5 PARAMETERS SETTING: SPEED LIMIT
Set the welding power source ON/OFF switch to “O” to switch the unit off.
Keep the lever lowered (SEL1).
Set the welding power source ON/OFF switch to “I” to switch on the unit.
SIMULTANEOUS ACTIONS
The acronym relative to the setting to be edited appears on the following displays: D1
The value relative to the selected setting appears on the following displays: D2
POT3 Using the potentiometer, edit the value of the selected setting.
Hold down the lever (SEL1) to save the setting and quit the menu.
ACRONYM PARAMETER MIN DEFAULT MAX
SP.L. SPEED LIMIT 1.0 m/min 20.0 m/min 20.0 m/min