Page
5
of
11
Revision: CT/Feb-/2020
2.4 Instructions
2.4.1 Ensure the proper adaptation of the reaction bar to the application.
2.4.2 Use only sockets and adapters which are in good condition and are intended for use with air
tools.
2.4.3 Ensure that the assembly air tool is securely fixed to suspension advice, if used.
2.4.4 Adopt suitable postures to counteract normal or unexpected movement of the air tool due to
reaction forces from the tool assembly.
2.4.5 Ensure that the pressure of the air or fluid supply is not lower than the lowest pressure
specified by the manufacturer for clutch controlled assembly tools and make sure that the air or
fluid supply pressure does not fail after the clutch has been set.
2.4.6 Release the start and stop device in the case of an interruption of the energy supply.
2.4.7Only lubricants recommended by the manufacturer shall be used.
2.5 Explanations of warning signs used for this tool
The operator’s
instruction must
be read before
work starts
Warning:
Risk of crushing
(intended for open-
ended spanners)
Warning:
Risk of crushing
(between the reaction
bar and the working
piece)
Direction of
rotation
2.6 Application
Rotary air tool, with a reversible spindle driving a hammer which periodically strikes an anvil which
includes a drive adapter for the purpose of tightening or loosening nuts and bolts without producing any
major torque reaction on the power tool.
2.7 The weight of this tool is about: 5.0 Kgs.
Note: If the weight of this tool exceeds 15 Kgs, the following attention shall be paid to
：
2.7.1 Be sure that you can afford the weight.
2.7.2 Be sure to wear foot protection, to prevent the risk of impact due to the drop of tool.
2.8 Specifications:
Part No.
Model
Square
Drive
Capacity
Bolt Size
Free
Speed
RPM
Max. Torque
Overall Length
Air
Inlet
(PT)
Air
Hose
(ID)
Continuous Air
Consumption
Net Weight
inch
mm
ft-lb
N.m.
inch
mm
scfm
l/min
lb
kg
403-722208 Impact Wrench
IW-PRO 3/4" NG
3/4”
1-1/4
32
4500
1200
1627
8.46
215
3/8”
3/8”
14
396
11.0
5.0