Wilfa DRY L WDH-20, Operating Instructions Manual

Page: 84 / 96

12
English
English
during this mode.
Basement mode, the machine will be set to activate and start drying the air, at high
fan speed, when the ambient humidity reaches above 45 %. User may set the fan
speed during this mode. The unit will then operate as the conditions described in
free drying.
Living room mode, the machine will be set to activate and start drying the air,
at medium fan speed, when the ambient humidity reaches above 50 %. User may
set the fan speed during this mode. The unit will then operate as the conditions
described in free drying.
Bedroom mode, the machine will be set to activate and start drying the air, at low
fan speed, when the ambient humidity reaches above 55 %. User may set the fan
speed during this mode. The unit will then operate as the conditions described in
free drying.
➏
CONTINUOUS Button
When continuous dehumidification mode is selected, the corresponding continuous
dehumidify indicator will be on, the dehumidifier will operate continuously at its
maximum dehumidification settings if attached to a hose to drain or until the bucket
is full.
A humidity level below 35 % is considered as dry air. To further lower the humidity
level is something that requires continues operation for a long time and is not
recommended for use in living rooms, bedroom and kitchen areas or similar.
Continues mode is recommended for use in areas with higher levels of humidity
such as basements areas or similar.
➐
FILTER Button
Press this button to turn oft Filter Cleaning Indicator. (When dehumidifier has been
operating for 250 hours, Filter Cleaning Indicator will be lit up to remind user of filter
cleaning.) The filter should be checked for regular maintenance every two weeks
disregarding of use.
Other Instructions
1. Alarm Warning
If bucket is full or not locked into place for over 3 min, buzzer will go off for 10s to
remind you to empty bucket or put it back into the correct place.
2. Auto Stop
When bucket is full, removed or not placed correctly or the humidity is 5 % lower
than the set humidity, unit will automatically stop.
3. Memory Function
If power is lost, all of the control settings are remembered. So when power is
restored, the unit will start back up in the settings it was in when power was lost.
4. Bucket full light
This indicates that bucket is full or removed or not placed correctly.
5. Clean the Filter On indicator light