Charging the headset
Use the USB cable provided to charge the headset.
When charging, the red LED is on.
When approaching the full battery level, the red LED goes down and the greed LED turns on.
When charging is complete, the LED goes down.
Turn on / turn off
To turn on:
Move the switch to the position “1”
The blue and the green LEDs flash several times.
To turn off:
Move the switch to the position “0”
Connection
Wildix WP600A Phone
Make sure the headset is switched on.
1) Press and hold the receiver button
, until the blue LED starts flashing
2) Go to the Wildix WP phone’s
Settings menu > Wireless & Networks > Bluetooth
and move the
switch to the position “ON”
3) Select WHS-BT from the list of AVAILABLE DEVICES
When connected, the headset’s blue and the green LED turn on for several seconds and there is the voice
prompt “Connected”
Wildix W-AIR 150 Handset
Make sure the headset is switched on.
4) Press and hold the receiver button
, until the blue LED starts flashing
5) Go to the Wildix W-AIR 150 handset’s
Settings menu > Bluetooth
and select “Enable Bluetooth”
6) Select “Search for devices”
7) Select the Wildix WHS-BT headset (the chipset number is shown) from the list of available
bluetooth devices and press “Pair”
8) Enter the PIN: 0000
When connected, the headset’s blue and the green LED turn on for several seconds and there is the voice
prompt “Connected”
Answer / End a call
To answer or to end a call, press the receiver button
on the headset
The blue and the green LEDs flash twice.
During the conversation the LED is off.
Wildix WHS-BT Bluetooth Headset - Quick Start Guide / 2
