W01/02PRI Pre 2017 - Quick Installation Guide - English
W01/02PRI Pre 2017 - Quick Installation Guide - English
Page 3 of 5
The Power LED on the device will be flashing when the device performs a DHCP server query. It will become
solid once it successfully gets an IP address from the DHCP server. At this point, you can now use the DHCP IP
address to access your device's management interface.
Connecting W01/02PRI using a static IP address
Before you start:
Your network interface must be set with an IP address in the 192.168.0.0/24 subnet (e.g. 192.168.0.11)
You must use an IPv4 Network
Make sure that your network connection is working
Steps
Connect a 10/100/1000 BaseT Ethernet RJ-45 cable into the ETH5ETH5/EXT Ethernet connector of the
device
Connect the other end of the cable into your PC
Validate the installation
Turn on the power sources that are used to power the PRI gateway at the circuit breaker
Turn on the power switch of the PRI gateway
Result
You can now use the 192.168.0.10 IP address to access your device's management interface.
Configuration of the gateway
For remote/ unreachable media gateways behind NAT/ Firewall, follow our
.
Trunk Settings Guide, BRI/ PRI Trunk Settings
Connection to the line
On the rear panel of the gateway, there are one or two modules with an Ethernet port marked as E1/T1 (Slot2
and Slot3).
Connect your PRI line to this port, as it is shown on the picture below:
