W-PA SIP Public Announcer - Admin Manual
W-PA SIP Public Announcer - Admin Manual
Page 5 of 7
1.
2.
3.
4.
After you set up a Dialplan, you can call the extension number you've assigned the device to from any
Wildix IP phone/ Collaboration/ Mobile app
W-PA will auto answer and play back your voice over connected speakers/ a microphone
If you want to finish broadcasting, press a Hang up button on the device you use for placing a call to hang
up
Ringtone Amplifier function
Starting from W-PA firmware version 2.1.1.3664, the device can be used as a ringtone amplifier.
Proceed with the following:
Assign W-PA to a user (Consult
Each time the user receives a call (Collaboration/ WP4X0/ Vision/ W-AIR Handsets/ Android, iOS
apps), W-PA
plays back
simultaneously
an amplified ringtone
Factory reset
In case you need to reconfigure your W-PA, you should perform a reset procedure.
To restart and restore the factory settings of W-PA SIP Public Announcer:
Press the
key with a paperclip and hold it for 3 seconds
Reset
Recovery procedure
It is possible to perform recovery procedure for W-PA. Consult
Appendix 1: W-PA Intercom function
Additionally, W-PA SIP Public Announcer can be used as the intercom system for unlocking doors. For this
purpose, you need to connect and configure external switch components. You can connect such switch
components as door release switches, door locks, intercom panels etc.:
Note: You can also configure W-PA to automatically play back pre-recorded messages at the fixed
time. Refer to
