Power Save
Power On
Setting Time
Test Mode
After 30 seconds without any
buttons being pushed, the LCD
will turn off and camera enters
into Power Save or Ready Mode.
1.
1.
Check the battery level icon to
ensure the batteries just installed
contain the proper charge level. If
so, you are ok to proceed with
camera use.
2.
Image Capture Status Light: The
LED status light illuminates
Green when the camera has
taken an image and is writing it
to the SD card.
1.
PIR LED Status Light: When the
LED status light illuminate Red
this indicates that the PIR sensor
has sensed a qualified event.
2.
The LCD screen can be awakened
by pressing the Power button
briefly.
Note: The LCD will not “wake up” when
camera is writing to memory.
2.
To turn the unit ON press and
release the power button.
1.
To change date and time, start by
pressing and release the center
navigation button to set the hour.
2.
Press the left or right navigation
button to go up or down in
sequence.
3.
When the hour is set, repeat
steps 1 and 2 to set the minutes.
page 5
page 6
Open
Open
NOTE: LCD cycle through camera
information. PIR picture number >
Flextime number > Remaining pictures
> Time
Ready
Clock
Date
Photos
Image
PIR
Resolution
Active
Delay
Still Video
Hi Med Lo
Hi Med Lo
24Hr
Day
Night
15s 30s 1m 2m
0432
PM
Ready
Clock
Date
Photos
Image
PIR
Resolution
Active
Delay
Still Video
Hi Med Lo
Hi Med Lo
24Hr
Day
Night
15s 30s 1m 2m
0432
PM
Ready
Clock
Date
Photos
Image
PIR
Resolution
Active
Delay
Still Video
Hi Med Lo
Hi Med Lo
24Hr
Day
Night
15s 30s 1m 2m
0432
PM
Ready
Clock
Date
Photos
Image
PIR
Resolution
Active
Delay
Still Video
Hi Med Lo
Hi Med Lo
24Hr
Day
Night
15s 30s 1m 2m
04
32
PM
LCD Ready Mode: The camera
will automatically enter the
Ready Mode if a button is not
depressed for greater than 30
seconds.
3.
Ready
Clock
Date
Photos
Image
PIR
Resolution
Active
Delay
Still Video
Hi Med Lo
Hi Med Lo
24Hr
Day
Night
15s 30s 1m 2m
0432
PM
