Main Switches
On Position:
• Electrical circuits are switched on. The engine can be started.
•
Do not leave the main switch in the on position for an extended period of time if
the engine is not running it will drain the battery.
Off Position:
• All electrical circuits are off and the engine is stopped. The key can be removed
in this position.
Steering Lock Position:
• Turn the handlebars to the left as far as they will turn, turn the key to the lock
position and remove. The front-end is now locked.
Please have your model number and the last 7 digits of your VIN# ready when you call for parts.
Have a problem - Need parts - Please call Toll Free (866) 658-7300 • Email: [email protected]
Steering Lock
Position
On Position
Off Position
6
Brakes
• Check the brakes before you ride each time if they are soft and spongy or are not
working properly, please replace immediately.
• Check your brake fluid level, add if necessary.
• Apply the brakes and make sure that the fluid is not leaking out of the brake lines or
the master cylinder.
NOTE:
Brake fluid may destroy painted surfaces or plastic parts, be sure to clean up
all spills.
Brake Fluid Level
1. When checking the fluid level make sure the top of the brake master cylinder is level
by centering the handlebars.
2. Refill with DOT 3 brake fluid. Mixing fluid may result in a harmful chemical reaction and
lead to poor brake performance.
3. Be careful that water does not enter the master cylinder when filling.
General Maintenance
Engine Oil Replacement
• Replace the engine oil after the first 50 miles with 5w50, 10w50 or 15W50 synthetic
engine oil. Then replace again every 1,500 miles. Check oil level every 500 miles, add
oil if needed.
Changing the Engine Oil
(1).Warm up the engine for a few minutes.
(2).Stop the engine.
(3).Place scooter on center stand.
(4).Place an oil pan under the engine and remove the dipstick.
(5).Remove the drain plug and drain the oil.
(6).Reinstall drain plug.
(7).Fill the engine with oil and install the dipstick. The recommended 5W50 until the level is in
the designated area on the dipstick.
(8).Start the engine and check for oil leaks. If a leak is found stop the engine
immediately and look for cause.
Final Drive Oil Replacement
• Replace the gear oil after the first 500 miles with 5W/50 synthetic engine oil. Replace the
gear oil again every 4 months or every 2000 miles.
• Replacing the Gear Oil
(1).Put the scooter on the center stand.
(2).Place an oil pan under the gear case.
(3).Remove the oil filler bolt and the drain plug to drain the oil
(4).Reinstall and tighten the drain plug.
(5).Fill the gear case with oil.
(6).Reinstall the oil filler bolt.
(7).Check for oil leakage.
Cleaning Air Cleaner
Be sure to check the air cleaner regularly.
(1).Place the scooter on the center stand.
(2).Unscrew and remove the left side panel.
(3).Remove the air cleaner cover by removing the
screws.
(4).Take out the air cleaner by removing the screws.
(5).Remove the air cleaner element and wash it gently, but thoroughly in solvent.
Replace if damaged.
(6).Squeeze out the excess solvent and dry it.
(7).Apply oil to the entire surface of the air cleaner and squeeze out the excess oil. It
should be damp but not dripping.
(8).Install the air cleaner, cleaner cover, and left side panel.
Spark Plug
NGK C7HSA
Gap .035
9
