4
2143014.04 05/2010 GB/D
GB
WIKA Operating Instructions Temperature Transmitter T19
1. Safety instructions
When mounting, initiating and operating these transmitters
it is important to observe the respective national safety
precautions and regulations in effect (e.g. VDE 100).
Nonobservance of the applicable regulations may cause
severe injury to persons or damage to equipment. Only staff
with suitable qualification should work with these transmitters.
Before initial operation check the suitability for the intended application.
In particular, it is important to fulfill the ambient and operation conditions
as specified in the WIKA data sheet TE 19.03. Use only configured
transmitters.
2. Before mounting
2.1 Transmitters with standard measuring ranges
Series T19 transmitters with standard measuring ranges are configurable
by means of solder bridges. Access to the solder bridges is gained after
removing the bottom of the casing. Mounted transmitters have to be
dismantled first before they can be configured.
To work properly, the transmitter has to be configured. Make
sure that the transmitter is configured before mounting.
Configuration is to be carried out as described in section 3.
As an option standard measuring ranges can be configured at the factory
and in this case the appropriate measuring range is printed on the rating
plate. Transmitters with standard measuring range configured at the
factory can be immediately fitted at the measuring point and put into
operation.
1. Safety instructions / 2. Before mounting
