Operation Manual
MIG-MAG Alu welding - brazing / VAS 821 003
©
Wieländer + Schill
Page 19
JOB
JOB
4.4 JOB Mode
The JOB mode allows you to store up to 100 individual parameter settings in addition to the
preset programs.
Change from synergic mode to JOB mode
JOB
is made
by short press of the JOB button . After entering the Job mode, the
number of the actual job is shown in the Material thickness / JOB
window. There are 100 jobs available: J00 – J99. By Turning the main
encoder the required job number can be chosen.
While in JOB mode, there are no set-up and adjustments available except
the JOB number and welding mode. If adjustment is required, JOB editing
must be activated – see following section
To quit from JOB mode press JOB button
JOB
again.
4.4.1
Editing / saving the JOB
While working in synergic mode
, by long pressing the JOB button
actual set up
can be stored. After long pressing of JOB button, number of job starts to flash. This number
can be changed by encoder rotation, after desired job number is set by pressing the encoder
button actual set up is saved under this job number.
To edit actual job, set job number to change, by long pressing the JOB button
the
material thickness start to flesh and any change of any parameter can be made. After
changes are made, by short press of the encoder button the settings will be stored.
4.5 Selecting the active feeder
Active feed unit selection is indicated by LED indicator above the corresponding euro torch
connector. To switch the idle feed unit on, the trigger button on the corresponding torch must
be pressed. By pressing the trigger button on the non-active feed unit, it will switch to active
state with automatic up-loading of all appropriate settings on the front panel. After releasing
the torch button and pressing it again the welding process will start.
4.6 Parameters setup for different feed units
There can be made specific setup for each feed unit. All settings made on the front panel
are belonging to the active feed unit and will be stored in internal memory in case of switching
the feed unit to idle state or switching the machine off. Always if some setup should be done,
the feed unit must be set as active.
Summary of Contents for VAS 821 003
Page 1: ...02 2021 MIG MAG ALU welding brazing Operation Manual REV 1 0 VW AG I VAS 821 003 UK ...
Page 30: ...MIG MAG Alu welding brazing VAS 821 003 _Operation Manual Page 30 Wieländer Schill ...
Page 31: ...Operation Manual MIG MAG Alu welding brazing VAS 821 003 Wieländer Schill Page 31 ...
Page 32: ...MIG MAG Alu welding brazing VAS 821 003 _Operation Manual Page 32 Wieländer Schill ...
