WiebeTech LLC
F o r e n s i c D r i v e D o c k + U s e r M a n u a l
- 2 -
2.
Attach bottom plate to your 3.5” hard drive. This step is optional but recommended.
The purpose of the
bottom plate is to provide protection to your drive electronics and aid heat dissipation. Attach the bottom plate to your
drive using the four screws supplied. Attach a rubber bumper to each corner. Extra bottom plates are available from
WiebeTech.
3.
Take a moment to familiarize yourself with the parts of your new DriveDock.
This will aid you in the
remaining steps.
4.
Configure the jumpers on your hard drive.
The drive must be set to the Master setting. Consult the
instructions for your drive (some drives display configuration information on the drive’s label). A few drives have both
“Master with Slave Present” and “Master without Slave” options. Choose the latter in this case. In rare cases, if the
Master setting does not work then try Cable Select.
A
DC +12V power input from AC adapter
B
1394a (FireWire 400) ports
C
4-pin DC input
D
Power Switch (On / Off)
E
4-wire power cable, connects to drive.
F
IDE ribbon cable, connects to drive.
a
+12V DC power input is present
b
Unit is write-blocked
c
Unit is connected to FireWire host
d
hard drive access
e
+12V Power output to drive
f
+5V Power output to drive
g
4-pin power input is present
Forensic
FireWire
Dr™
+12
+5
4 PIN
0
|
+12
(Example)
LEDs