1250W/1500W ROTARY HAMMER ENG
13. Operation your power tool
1) Position the bit at the desired location for the hole, then to pull the switch trigger. Do not force the
tool. Light pressure gives best results. Keep the tool in position and prevent it from slipping away
from the hole (See Fig 13).
2) Do not apply more pressure when the hole becomes clogged with chips or particles. Instead, run
the tool at an idle, and then remove the bit partially from the hole. By repeating this several times, the
hole will be cleaned out and normal drilling may be resumed.
14. Lubrication
This tool requires no hourly or daily lubrication because it has a grease-packed lubrication system.
Lubricate the power tool when impact energy is weak. To lubricate remove the oil cover at the top of
the power tool using the spanner provided (See Fig 14). Wipe out the old grease inside and replace
with fresh grease (approx. 25g). Use only the grease provided with your power tool. The grease
specification is general purpose lithium based. Reinstall the oil cove and tighten with the spanner.
Run the power tool for several minutes to warm it up. Switch off and unplug the tool.
Note:
Do not tighten the oil cove excessively. It is made of plastic and is subject to breakage.
WORKING HINTS FOR YOUR POWER TOOL
1. Always use sharp good quality drill bits and chisels. The performance of the drill is dependent on
the quality of the bits used.
2. Reduce the pressure on the drill bit when it is about to break through. This will prevent the drill bit
from jamming.
3. When drilling a large hole in tough material (i.e. steel), we recommend drilling a small pilot hole first
before using a large drill bit.
4. When drilling tiles, select the drill position to drill the tile. When tile has been penetrated, select
hammer drill position.
5. Always apply pressure to your drill bit in a straight line, and if possible at right angles to the
workpiece.
6. Do not apply excessive pressure to the power tool when hammering or chiseling. Expressive force
does not speed up the work.
7. If your power tool becomes too hot, set the mode selector lever to position “ ”, set the mode
selector knob to position “ ”, run no load for 2-3 minutes to cool the motor.
MAINTENANCE
Warning: Remove the plug from the socket before carrying out any adjustment,
servicing or maintenance.
1. Never use water or chemical cleaners to clean your power tool. Wipe clean with a dry cloth.
2. Always store your power tool in a dry place.
3. Keep the motor ventilation slots clean.
4. If you see some sparks flashing in the ventilation slots, this is normal and will not damage your
power tool.
5. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
12
Summary of Contents for WD011320036
