Widinovations widlaser C1000, User Manual

Page: 10 / 41

widinovations Confidential ©
10
Risk posed by non-repairable faults!
Any non-repairable fault may damage the machine.
Turn off the machine and call customer service!
Risk posed by using inferior spare parts or parts of other manufacturers!
The use of inferior spare parts or parts produced by other manufacturers impairs the safety of the machine and
invalidates the Declaration of Conformity (CE) supplied with it.
Wear parts or damaged mechanical, safety or electrical components should be replaced by original spare parts.
Risk posed by missing protective equipment!
Wear the appropriate workwear.
Wear safety glasses (class 4/USA: Class IV)
Use a suitable extraction system.
Risk posed by laser cutting and engraving reaction on products!
A suitable extraction system must be used when laser marking due to the possible generation of gases, fumes
and any other partially toxic by-product.
In individual cases, the reaction products may consist of static dust. If this enters any electrical systems it can
cause short circuits leading to personal injury and material damage.
Risk posed by flammable or explosive materials!
Class 4 laser radiation such as that emitted by the widlaser C1000 may ignite materials or cause explosions.
Among others it should be ensured that:
Parameters are selected so that the material does not overheat.
The system is monitored if necessary.
Dust is extracted safely.
There is no accumulation of any flammable residues or remnants in the workspace.
Depending on the materials being processed and the parameters selected, laser cutting or engraving may
generate gases, fumes, aerosols or dust. The toxicity of such by-products depends on the material. The operator is
responsible for ensuring and maintaining a suitable extraction system in place and for compliance with the relevant
guidelines in order to protect individuals and the environment.
The machine is equipped with an observation main door made of laser resisting plastic. In order not to damage it,
it should only be cleaned with clean water and possibly a little detergent if necessary. Use a soft cloth in order not to
scratch the surface.
ATTENTION
Benzene, alcohol, acetone, solvent or similar cleaning agents will damage the laser protection polycarbonate,
which must be replaced immediately.
Scratches must also be avoided. The laser protection polycarbonate must be replaced immediately if it
becomes damaged.