12
The hex key (15) is placed at the position as shown.
3. HEX KEY STORAGE (SEE FIG. B)
15
10
2
1
Fig. A3
Fig. A4
Ensure the blade is located and runs smoothly in the groove (SEE FIG. A3), otherwise the pendulum function will not
work correctly and the blade will not be supported during cutting.
2. ROLLER GUIDE
1) Using the supplied hex key to loosen the bolts securing the base plate by turning the bolt anti-clockwise. (See Fig. C1)
2) Slide the base plate backwads to be loose. (See Fig. C1)
3) Rotate the base plate to a required angle (0°, 15°, 30°, 45°). For other miter angles, rotate to your desired angle (use a
protractor scale). (See Fig. C2)
4) Hold the base plate in position, slide the base plate forwards to match the groove to lock. (See Fig. C3)
5) Firmly tighten the bolt by turning the bolt clockwise to clamp the base plate at the desired angle. (See Fig. C4) Check
the angle and ensure the base plate is firmly clamped.
NOTE:
The angle markings on the base plate are accurate for most general purposes but it is recommended for accurate
work to set the angle with a protractor and make a test cut on other material.
4. ADJUSTING THE CUTTING ANGLE (SEE FIG. C1- C4)
Fig. B
