Wickes 223730, Manual

Page: 12 / 20

12
CHARGING PROCEDURE
1) Plug the charger (12) into an appropriate outlet. The
green LED will be lit.
2) Slide the battery pack (7) into the charger, the red LED
will light to indicate charging.
3) When charging is completed, the green LED will light.
The pack is now fully charged, unplug the charger and
remove the battery pack.
WARNING: If the battery pack is warm e.g. after
continuous use or after exposure to direct sunlight or
heat, allow time to cool down before re-charging to
achieve the full charge.
Light Status
Red on
Charging
Green on
Fully Charged
D) HOW TO CHARGE YOUR BATTERY PACK (See Fig. A3)
Depress the On/Off switch (10) to start and release it to
stop your drill. The on/off switch (10) is fitted with a brake
function which stops your chuck immediately when you
quickly release the switch.
It is also a variable speed switch that delivers higher
speed and torque with increased trigger pressure.
Speed is controlled by the amount of On/Off switch (10)
depression.
WARNING!
Do not operate for long periods at
low speed because excess heat will be produced
internally.
1. ON / OFF SWITCH (See Fig. B)
OPERATION
Fig. B
Fig. A3
The On/Off switch (10) can be locked in the OFF position. This helps to reduce the possibility of accidental starting when
not in use. To lock the On/Off switch (10), place the rotation control (4) in the center position.
2. SWITCH LOCK (See Fig. B)
12
1
2