Wickes 223729, Original Instruction

Page: 13 / 20

13
Forward rotating: push the forward/reverse rotation
control (4) to the left (the drill points away from you). It is
used for drilling and screw driving.
Reverse rotation: push the forward/reverse rotation
control (4) to the right (the drill points away from you). It
is used for remove screws or release a jammed drill bit.
WARNING!
Never change the direction of rotation
when the chuck is rotating, wait until it has
stopped!
The drill has a two-speed gear control (3) designed
for drilling or driving at LO (mark is 1) or HI (mark is 2)
speeds. A slide switch is located on top of the drill to
select either LO or HI speed. When using the drill in the
LO speed range, the speed will decrease and the drill will
have greater power and torque. When using the drill in
the HI speed range, the speed will increase and the drill
will have less power and torque.
GEAR I
Low speed range: for screwdriving or working
with large drilling diameter
GEAR II
High speed range: for working with small drilling
diameter
WARNING! To prevent gear damage, always allow the
chuck to come to a complete stop before changing
the direction of rotation or the two-speed gear control.
To open the chuck jaws rotate the front section of the
chuck (1). Insert the drill bit between the chuck jaws and
rotate the front section in the opposite direction. Ensure
the drill bit is in the center of the chuck jaws.
Finally, firmly rotate the front chuck section in the
opposite directions. Your drill bit is now clamped in the
chuck.
3. REVERSIBLE (See Fig. C1, C2)
4. TWO-SPEED GEAR CONTROL (See Fig. D)
5. CHUCK ADJUSTMENT (See Fig. E)
Fig. C1
Fig. C2
Fig. D
Fig. E
1
2