Selection Of Output Connection:
Please choose wires with suitable diameter/cross section based on the current rating. Please refer to the following table for the information of
some frequently used wires. Using red wires to connect the (+) terminals and black ones for (-) terminals is highly recommended.
AWG
CROSS SECTION(mm
2
)
Max.Current(A)
UL1015(600V 105
°
C)
10
5.262
35
12
3.309
22
14
2.081
12
16
1.309
8
Suggested Battery Capacity:
1. Batteries larger than shown may be charged, it just takes more time to reach full charge.
2. Questions about suitable charging currents should be referred to the battery manufacturer and published data.
Model
Suggested Battery capacity
CC-1215W
60-120Ah
Fault Finding:
Status
Possible Reasons
Ways to Eliminate
No output
voltage
Power switch is not set to ON(-)
Set the power switch to
ON(-)
Wrong polarity of the battery
connection (output fuse open)
Replace the fuse
Wrong selection of the 115/230Vac
switch
Repair required. Please
send it back to us or any
of our distributors
Output voltage
is too low
Wrong selection of the 115/230Vac
switch
Choose the correct input
voltage range through the
115/230Vac switch
Can't achieve
the FLOAT
(green light)
stage after
long period
of charging
operation
Batteries are aging or faulty
Replace the batteries
The battery has a load on it
Remove the load or seek
advice on ways to adjust
the charger to suit the load
If you still cannot solve a problem, please consult Wialki Electronics as below.
WARNINGS:
Explosive gases may be present while charging batteries. prevent flames and sparks.
Provide adequate ventilation during charging.
Disconnect the supply before making or breaking the connections to the battery.
Only charge lead acid type batteries
Cautions:
Temperature of the case will be high during the charging operation.
For safety only use a properly grounded outlet
The charger should be fixed firmly at its place of operation or be mounted on a holding rack for extra support.
Reserved space for built in should be at least (325*145*55) L*W*H
Wialki Electronics
Unit 7 13-15 Harvard Way
Canning Vale WA 6155
Ph: (08) 9455 2245 Fax: (08) 9455 2137
Web:
www.wialkielectronics.com.au
Email:
