RF Exposure
This equipment complies with FCC radia
ti
on exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 8” (20cm) between the pocket
and your body. This transmi
tt
er must not be co-located or opera
ti
ng in conjunc
ti
on with any other
antenna or transmi
tt
er.
FCC Informa
ti
on
FCC ID: SO4YX110
Warning: Changes or modi
fi
ca
ti
ons to this device not expressly approved by Wi-Ex could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protec
ti
on against
harmful interference in a residen
ti
al installa
ti
on. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruc
ti
ons, may cause harmful
interference to radio communica
ti
ons. However, there is no guarantee that interference will not occur in
a par
ti
cular installa
ti
on. If the equipment does cause harmful interference to radio or television recep
ti
on,
which can be determined by turning the equipment o
ff
and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separa
ti
on between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit di
ff
erent from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
RF Exposure:
The Manufacturer's rated output power of this equipment is for single carrier opera
ti
on. For situa
ti
ons
when mul
ti
ple carrier signals are present, the ra
ti
ng would have to be reduced by 3.5 dB, especially
where the output signal is re-radiated and can cause interference to adjacent band users. This power
reduc
ti
on is to be by means of input power or gain reduc
ti
on and not by an a
tt
enuator at the output of
the device.
Industry Canada Regula
ti
ons
IC: 5544A-YX110
This Class B digital apparatus meets all requirements of the Canadian Interference Causing Equipment
Regula
ti
ons. Opera
ti
on is subject to the following two condi
ti
ons: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may
cause undesired opera
ti
on.
The term “IC:” before the radio cer
ti
fi
ca
ti
on number only signi
fi
es that Industry Canada technical
speci
fi
ca
ti
ons were met.
Cet appareillage numérique de la classe B répond à toutes les exigences de l’interférence canadienne
causant des règlements d’équipement. L’opéra
ti
on est suje
tt
e aux deux condi
ti
ons suivantes: (1) ce
disposi
ti
f peut ne pas causer l’interférence nocive, et (2) ce disposi
ti
f doit accepter n’importe quelle
interférence reçue, y compris l’interférence qui peut causer l’opéra
ti
on peu désirée.
Le terme "IC" avant que le nombre par radio de cer
ti
fi
ca
ti
on signi
fi
e seulement que des caractéris
ti
ques
techniques du Canada d'industrie ont été rencontrées
