![background image](http://html.mh-extra.com/html/whynter/chc-122bd/chc-122bd_instruction-manual_978477009.webp)
9
Installation
ELECTRICAL CONNECTION
This appliance requires a standard 115/120 Volt AC ~/60Hz electrical ground outlet with three
-
prong.
Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly
grounded. The cord should be secured behind the appliance and not left exposed or dangling to prevent
accidental injury.
The appliance should always be plugged into its own individual electrical outlet which has a voltage rating
that matches the rating label on the appliance. This provides the best performance and also prevent over-
loading house wiring circuits that could cause a fire hazard from overheated. Never unplug the appliance
by pulling the power cord. Always grip the plug firmly and pull straight out from the receptacle. Repair or
replace immediately all power cords that have become frayed or otherwise damaged. Do not use a cord
that shows cracks or abrasion damage along its length or at either end. When moving the appliance, be
careful not to damage the power cord.
EXTENSION CORD
Because of potential safety hazards, it is strongly recommended that you do not use an extension cord
with this appliance. However, if you must use an extension cord, it is absolutely necessary that it be a
UL/CUL
-
Listed, 3
-
wire grounding type appliance extension cord having a grounding type plug and outlet
and that the electrical rating of the cord be 115 volts and at least 10 amperes.
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packing.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the door
HANDLE BAR
To install the handles, you will need a Phillips head
screwdriver.
1.
Open the door.
2.
Locate the two screw holes on the inside of the door
(they may be partially obscured by the door seal so
you may need to remove the door seal).
3.
Insert the screws into the screw holes until they stick
out of the front of the door.
4.
Line up the holes in the handle with the screws and
give each screw about 2
-
4 full turns into the handle
bar.
5.
Now the turn the screws in all the way, and your han-
dles are installed.
6.
Replace seal into door frame.
WARNING: Improper use of the grounded plug can result in the risk of electrical shock.
If the power cord is damaged, have it replaced by a qualified electrician or contact
Whynter Service Department.
SCREWS
DOOR
SEAL
HANDLE
BAR
DOOR