E
E
C
F
x 4
x 2
Page 3 – 5025KFDH - 01/09/09
B
G
A
A
F
F
5025KFDH Portland II Trestle Table
ASSEMBLY INSTRUCTIONS
x 4
G
x 4
E
Fig. 1
Fig. 2
TOOLS REQUIRED: Hex Wrench (provided), Phillips Screwdriver,
Mallet or Padded Hammer, Wood Glue, Slotted Screwdriver
1.
Spread a thin film of glue into the dowel holes of the Top Support (B) and place over dowels
of the Leg (A). Gently tap with a padded hammer and quickly wipe away any excess glue.
Secure with #8x1¼" Pan Head Screw (G). See Figure 1.
2.
Spread a thin film of glue in the dowel holes on the Legs (A). Insert Middle Support (C) and
quickly wipe away any excess glue. See Figure 2.
Secure with ¼"x66mm Hex Bolts (E) and Barrel Nuts (F).
NOTE:
The bottom of the Barrel Nut
is grooved. When you insert the nut into the Middle Support, make sure the grooved end points
out (either up or down) so you can use a slotted screwdriver to properly align the nut.
See Figures 2a and 2b.
Fig. 2a
Fig. 2b
