3507AFGACb; 3507AFCAFb McKenzie Square Cocktail Table
Assembly Instructions
3507AFGACb_3507AFCAFb
— Page 3 — 08/14
Tools Required: Phillips Screwdriver, 9/16" or Adjustable Wrench, Rubber Mallet or Padded
Hammer
1.
Turn the Top Assembly (A) upside-down on a clean, protected surface. Place a Left Front/Right
Back Leg (Ca) and the Right Front/Left Back Leg (Da) at one side of the Top, making sure the
drilled corners of the legs face toward the Corner Blocks. It is important the side of the leg
exposing the wheel face each other. LOOSELY attach with 5/16" Flat Washers (J) and 3/8" x 2-
1/2" Hex Bolts (K) (the legs should be wobbly). Repeat for the other two legs on the opposite
side. See Figures 1 and 1a.
2.
Turn the Top/Leg Assembly on its side and with the bottom side of the Shelf Assembly (B)
facing down and place the dowels into the dowel holes in the Legs. Tighten the Hex Bolts on the
Legs. See Figure 2.
Fig. 2
B
Fig. 1
A
Fig. 1a
Ca
Da
Ca
Da
J
K
J
K
J
K
x 4
x 4