3501GACc, 3501CAFc McKenzie End Table
Assembly Instructions
3501GACc_3501CAFc — Page 3 — 03/17
Tools Required: Phillips Screwdriver, 9/16" or Adjustable Wrench
1.
Remove the Drawers (E) from the Case Assembly (Ac). To remove the drawers, pull up on the
left side of the Drawer Release Lever while pushing down on the right Drawer Release Lever.
See Figure 1a. Note where each drawer came from to ensure correct installation.
2.
Turn the unit upside down on a clean, protected surface. Place two Legs (C) at the front corners
of the Case Assembly (Ac) making sure the drilled corners of the legs face toward the Corner
Blocks. Insert two 3/8" x 2-1/2" Hex Bolts (R) with two Flat Washers (Q) through the Corner
Blocks and into the leg and fasten securely. See Figures 2 and 2a. Repeat for the other two
legs.
Fig. 2
Q
R
x 8
x 8
Fig. 2a
Q
R
C
C
R
Q
Ac
Fig. 1
Drawer Release Lever
Fig. 1a