3452AFCAFa Stayton End
Table
Assembly Instructions
3452AFCAFa
— Page 3 — 03/14
Tools Required: Phillips Screwdriver, 9/16" or Adjustable Wrench, Rubber Mallet or Padded
Hammer
1.
Remove the Drawer (D) from the Top Assembly (A). To remove the drawer, pull up on the left
side of the Drawer Release Lever while pushing down on the right Drawer Release Lever. See
Figure 1a.
2.
Turn the Top Assembly (A) face down on a clean protected surface. Place a Side Assembly (B)
against one side of the Top Assembly as shown. Insert four #8 x 1-
1/4” Pan Head Screws (J)
through the holes in the Side Apron into the Side Assembly. Insert one #8 x 1-
1/4” Pan Head
Screw (J) through the pocket hole in the Back Apron into the Side Assembly. See Figure 2.
Fig. 1
Drawer Release Lever
Fig. 1a
Fig. 2
B
A
J
x 5
J
J
