2400GACd 2400CAFd McKenzie 3-Drawer Desk
Assembly Instructions
2400GACd_2400CAFd — Page 4 — 05/17
Tool Required: Phillips Screwdriver, 9/16" or Adjustable Wrench, Mallet or Padded Hammer
1.
Remove the drawers from the Case Assembly (Ac). To do that, pull up on the left Drawer
Release Lever while pushing down on the right Drawer Release Lever and pull out the drawer.
See Figure 1a. Note where each drawer came from to make sure you place them back into their
correct positions.
2.
Turn the Case Assembly (Ac) upside-down on a clean protected surface. Be careful not to
engage the touch-latch on the pull-out writing/working surface. Place a Leg (D) into the right
front and back corners, making sure the drilled portions of the legs face the corner blocks. Insert
four 3/8" x 2-1/2" Hex Bolts (ZF) with four 5/16" Flat Washers (ZE) through the corner blocks
and into the Legs (D). Fasten securely. See Figures 2 and 2a.
Fig. 2a
ZE
ZF
x 4
x 4
ZE
ZF
ZF
ZE
D
Ac
Fig. 2
Fig. 1
Drawer Release Lever
Fig. 1a
