2074AFGACg; 2074AFCAFg 73"W McKenzie Center Channel Console
Assembly Instructions
2074AFGACg_2074AFCAFg
— Page 4 — 07/14
Tool Required: Phillips Screwdriver, Pencil.
1.
Place the console at its final destination. Rotate the Adjustable Glides (ZG) found at the corners
of the unit and (YD) at the bottom of the Center Foot until the unit is level. See Figure 1.
2.
To open the Speaker Door (Ha), press both corners until the magnets release. Gently grasp the
finger groove in the top middle of the door and pull open. To shut the door, push gently but
firmly on the Speaker Door until the Tuscan Magnetic Plates (YE) make secure contact with the
Magnetic Push Locks (R). See Figure 2.
If you need to install your speaker from the back, remove the 18 #6 x 5/8" Philtruss Screws (W)
and pull away the Fitted Back (ZT). After installing the component, replace the Fitted Back and
attach with the 18 #6 x 5/8" Philtruss Screws (W). See Figures 2a, 2b, 2c.
Fig. 2
YE ZT YE
Ha
R
R
Fig. 2a
Fig. 2c
Fig. 2b
W
W
ZL
ZT
Fig. 1
ZG
YD
ZG
