1356AFGAC; 1356AFCAF McKenzie Twin Headboard
1357AFGAC; 1357AFCAF McKenzie Full/Queen Headboard
1358AFGAC; 1358AFCAF McKenzie King/Cal-King Headboard
— Parts List
A — Headboard Assembly — Qty.1
(for 1357AFGAC; 1357AFCAF
& 1358AFGAC; 1358AFCAF)
1357AFGAC shown above.
F — Headboard Assembly
— Qty.1
(for 1356AFGAC; 1356AFCAF)
B — Block 1
— Qty. 2 (attached)
G — Block 2
— Qty. 2 (attached)
C — #12 x 2-1/2" Pan Head
Screw — Qty. 8 (inserted)
Page 2 — 1356AFGAC_1356AFCAF_1357AFGAC_1357AFCAF_1358AFGAC_1358AFCAF — 07/10
(for 1356AFGAC; 1356AFCAF)
(for 1357AFGAC; 1357AFCAF
& 1358AFGAC; 1358AFCAF)
H — #8 x 1-5/8" Black Screw
— Qty. 4 (inserted)
I — #8 x 20mm Pan Head Screw
— Qty. 17 (inserted)
(1356AFGAC; 1356AFCAF)
— Qty. 22 (inserted)
(1357AFGAC; 1357AFCAF)
— Qty. 26 (inserted)
(1358AFGAC; 1358AFCAF)
D — #12 x 1-1/4" Pan
Head Screw — Qty. 6
E — Washer
— Qty. 6
Assembly Instructions
Tools Required:
Drill, 1/8" bit, Phillips screwdriver
1.
IF YOU ARE USING A HOLLYWOOD BED FRAME:
Adjust the Hollywood frame to fit your matress and box spring.
2.
Place the Headboard (A) against the end brackets of the frame and mark the locations for
the screws. Drill pilot holes approximately 1-1/4" deep. (To make sure you don’t drill deeper,
measure 1-1/4" up from the end of the drill bit and wrap a piece of tape around the bit. Stop drilling
when the edge of the tape meets the wood.)
3.
Position the Headboard (A) against the frame and attach using #12 x 1-1/4" Pan Head Screws (D)
and Washers (E).
Please identify the parts and check that quantities received match those on this list.
If you need to replace a part, refer to the following letter and model name.