1137AFGSPd; 1137AFCAFd Pacific 9-Drawer Dresser
Assembly Instructions
1137AFGSPd_1137AFCAFd
— Page 4 — 07/13
Tool Required: Phillips Screwdriver
1.
Place the unit at its final destination. Rotate the Small Adjustable Glides (Y) found at the corners
of the unit and the Adjustable Glide with Hex Nut (ZW) at the bottom of the Assembled Foot
(ZX) until the unit is level. See Figure 1.
2.
Tipping restraint:
Locate two studs in the wall behind the unit. Attach a Clip (T1) to one wall
stud with two #8 x 2" Black Screws (T3). See Figure 2a. Attach a second clip to the unit with two
#6 x 5/8" Philtruss Screws (T5). See Figure 2b. Connect the two clips with the Nylon Restraint
Strap (T2). Pull the Nylon Restraint Strap (T2) tight so there is no slack. See Figures 2c and 2d.
Repeat this procedure to attach the second tipping restraint. If you cannot locate two studs,
purchase the proper wall attachment hardware for your type of wall and secure the unit.
Fig. 2a
T1
T3
Pull tight
Fig. 2d
T1
T2
T5
Fig. 2c
Pull the Nylon Restraint
Strap (T2) tight
so there is no slack.
T3
T5
T1
Fig. 2b
Fig. 1
ZX
ZW
Y
Y
