3.
Place the Caster (Vc) over the prepunched holes in the bottom of the Foot (Jc). Screw the Caster
down with four #10 x 3/4" Pan Head Screws (R). Repeat for the other three Feet. See Figure 3.
Fig. 3
Vc
Jc
R
4.
Fig. 4
II
Gc
Q
Place the Leg Assembly on the floor. Slip the Cylinder Cover (X)
over the Gas Cylinder. The smaller upper section should lock on
the cylinder. Lower the chair seat on to the Gas Cylinder so that the
chrome section fits into the hole in the Tilter Mechanism (H). Sit in the
chair to secure the fit. This will lock the Gas Cylinder to the
Tilter Mechanism.
5.
Fig. 5
NOTE: The largest outer ring
of the Cylinder Cover is not
required and may be discarded
if you choose not to use it.
X
II
H
Page 4 — 688GACc_688CAFc — 12/19
Insert the Gas Cylinder (II) into the Pedestal Assembly (Gc). The lip on the Cylinder may not sit flush
against the top of the Pedestal. With a 1/8" drill bit, drill pilot holes 3/4" deep through the holes in the
gas cylinder lip and into the Pedestal. Insert four #10 x 1-1/4" Black Pan Head Screws (Q) through
the Gas Cylinder and into the Pedestal and securely fasten. This will draw the lip flush against
the Pedestal. See Figure 4.
