Spectra Assembly Guide 7
return to searching. Initial battery check voltage may indicate abnormally high.
With new Alkaline, or a fresh battery charge, the most accurate battery voltage
will be indicated after one hour of use.
Using the Standard Battery Holder
• Slide open the battery holder lid (decal side of battery holder) by applying
gentle upward pressure on the single large tab of the door so that it unlocks.
Slide the door away from the battery box exposing the cell positions.
• Remove any old cells from the holder. Note the “+” and “-“ positions of
each cell and the “+” and “-“ for each position marked inside the cell tray. Install
new “AA” cells noting carefully the correct (+) and (-) positions. If any of the
cells are installed incorrectly, battery life will be significantly reduced and/or the
Spectra may require service by an Authorized Service Center.
• Slide the door closed so that it snaps securely.
• Insert the battery holder into the detector so that the decal is
facing down, with the single larger battery holder door tab and metal contact
points facing toward the inside of the battery compartment. Close the battery
compartment door and secure the two latches on the bottom of the case. Hook
the front (nearest the door) of each latch first, and then snap down the rear
(furthest from the door).
Summary of Contents for V3
Page 1: ......
