GOLDMASTER
®
24k
ASSEMBLY
DISPLAY/CONTROLS
FEATURES
GOLDMASTER
®
24k
1 Attach the lower rod to the
search coil - washers inside
coil ears, then bolt and nut
2 Assemble the 3 rod sections
to best fit your body
3 Carefully wrap and secure the cable
around the shaft of the detector
4 Connect the coil cable to the back of the pod
5 Insert the battery pack
6 Insert headphones to the back of the detector
1
2
4
5
6
3
NOTE: Black REGULAR text = button TAP,
Blue ITALIC text = button HOLD
®
Target ID #
Higher number,
Better chance of gold
Beep Mode On
Iron Cancel On
Volume Level
SAT/Theshold Level
Sensitivity
TracLock On
Backlight On
Visual Target ID
Ground strength in
Ground Scan mode
®
Audio Mode
SAT +/-
Backlight
Ground Scan
Pinpoint (non-motion)
Thr/-
Disc LO/HI
/-
Iron Cancel
Ground Grab/Exit Setting Selection
TracLock
Power On/
Off
Sensitivity
Adjust other settings
SENSITIVITY -
Set the sensitivity at a level that does not result in
false signals from the ground. Very strong ground may result in the
symbol on screen and a loud sound - this means the sensitivity is too
high.
GROUND BALANCE -
With the default setting, the detector will use
XGB to automatically ground balance. Tap to lock the ground
balance to the current setting. Tapping when the ground balance is
locked will update the current ground setting to what is under the coil.
GROUND SCAN -
Hold to put the detector into Ground Scan mode.
The top bar displays the ground strength and the two digit numbers
display the ground type (phase). Useful for tracing paystreaks.
IRON CANCEL -
Tap to silence hot rocks, trash and mineral
changes in both audio modes. Hold to adjust the Iron Cancel
setting (tap the button to cancel high-wrap hot rocks). Note that this
setting may decrease the detector’s sensitivity to very small gold, but is
necessary in difficult ground conditions.
VOLUME and THRESHOLD -
Tap to adjust the volume with the up
and down buttons. Hold to adjust the threshold with the up and
down buttons (“th” displays on screen). With the volume at levels over
8 you can enable Boost 1 and Boost 2 for maximum sensitivity.
AUDIO MODE -
With the displayed on screen, the detector is in
“BEEP” audio mode (high tone = good target, low tone = bad target).
The default setting (without on screen) is a traditional All-Metal
audio mode with greater sensitivity to small targets.
SAT -
SAT can smooth out ground inconsistencies. Hold to adjust it
(“Sa” displays on screen, 2 is the default setting).
PINPOINT -
Hold for non-motion pinpoint mode. In difficult
ground this mode may be affected by mineralization.
BACKLIGHT -
Tap to enable the backlight (this reduces battery life).
FREQUENCY SHIFT -
Hold when turning the detector on to shift
frequency (useful when there is EMI). Power off to save the selection.
FACTORY RESET -
Hold when turning on the detector. Press the
button when “Fd” is on screen to reset the machine to factory default.
