Whitecroft Lighting Limited
MSU Surface / Radial AL
Electrostatic
Sensitive Device
High Voltagle
LED's
13.
Slide in the two End Spacers into position under the 6mm P/C and fix in place with the centre
screw.
14.
Replace all the other 14 screws. Torqe to 1.2Nm. The anti-tamper screws require a special
allen key (3mm with centre hole) or bit (sold separately - HAL-KEY3) ensure screws are sufficiently
tightened.
15.
Remove film on the ouside of the 6mm Screen.
16.
Use a suitable anti pick mastik around the base to optain IP54 rating on luminaire.
PLEASE NOTE
If the luminaire is controlled via DALI, then choose one of the options below:
Option 1. If using a fully addressable system i.e. only a single DALI pair is supplied to the fitting then
the DALI & DALI EM terminals need to be linked as shown in the images above.
Option 2. If using a DALI broadcast system i.e. DALI control for the ftting and a seperate DALI EM
coms for self test interrogation ,
DO NOT ATTACH THE LINK CONNECTIONS.
10.
For Emergency versions connect the battery to the inverter.
11.
Lift and slide the reflector into position in the body and secure with the 4 refelctor screws.
12.
Hold the 6mm P/C screen countersunk side down with the lumieo held matt down in place with
2 screws, lift up to the body and fit the screws in place with the HALKEY3.
Whitecroft Lighting Limited
MSU Surface / Radial AL
Electrostatic
Sensitive Device
High Voltagle
LED's
