Height
Diameter
Top
Diameter
Bottom
Weight
1100mm 190mm
270mm
7.1kg
SPECIFICATION
The Broadwalk L360 is a floor mounted bollard. The
luminaire must be mounted on a concrete base
300mm diameter x 400mm deep with a 230v supply
through middle of base
Each Broadwalk L360 is shipped in one
package
Before commencing installation, check
contents of all carton to ensure that all
components are present and in good
condition.
1) Main body
2) IP66 Grommet
3) 3x Anchor bolts
INSTALLATION SEQUENCE
In order to fit this luminaire, the correct
sequence of assembly must be observed.
During Installation make sure the power is
completely isolated at the mains.
1. Remove the fitting from its
packaging along with the IP66
grommet and anchor bolts
2. Take the IP66 grommet and wire
your cable into the screw
terminals. (diameter= 9 to12mm,
1.5 mm², Core rubber Insulated )
(Fig 1).
3. Tighten the IP66 seal round the
cable and push the connector into
the grommet housing until it
clicks. (Fig 2).
4. Place the luminaire on the top of
the concrete base and drill 3
equal distance holes so they
match the holes on the base of
the luminaire.
5. Connect the cable to the bottom
of the luminaire and twist the
housing until it clicks into place.
(Fig 3).
6. Take the anchor screws and
place in the holes, aligning them
exactly. (Fig. 4).
7. Tighten until the luminaire is
totally secure and cannot be
moved. (Fig 4).
Fig 4
H=400mm
