8
Attaching Drive Adjuster Block
The drive adjuster block is attached to the drive cable.
1.
Remove bolt attached to the lower right handle.
2.
Align the drive adjuster block with hole in handle. Its
curved side goes against the handle,
3.
Secure drive adjuster block with the bolt previously
removed. See Figure 5 .
Figure 5
Attaching Starter Rope
The rope guide is already attached to the right side of
the lower handle of your mower. See Figure 6 .
1.
With spark plug wire disconnected and grounded,
hold the blade control handle against the upper
handle, and pull the starter rope out of the engine.
2.
Slip the rope through the rope guide as shown
below. Tighten the wing nut holding the rope guide
to the handle
Figure 6
Assembling Grass Catcher
NOTE:
If the grass catcher came pre-assembled,
proceed to the next section. If not, follow the steps
below to assemble it before attaching to the mower.
1.
Insert frame into grass bag with the black plastic
side on the bottom of bag. See Figure 7.
Figure 7
2.
Slip the side openings on the plastic channel of the
grass bag over the hooks on the grass catcher
frame. Secure bag to the frame by working the six
plastic channels.
IMPORTANT:
Entire channel except the center top of the
bag attach from outside of bag. The center top of the
bag attaches from inside of bag. See Figure 7.
Attaching Grasscatcher
1.
Lift the rear discharge door and place the grass
catcher on the pivot rod. Let go of the discharge
door so that it rests on the grass catcher. See
Figure 8.
Figure 8
Bolt
Drive
Adjuster
Block
Wing Nut
Rope
Guide
Starter
Rope
Blade Control Handle
Upper Handle
Lower Handle
WARNING:
If using the grass catcher, the
hooks on the grass catcher must be firmly
seated on the chute pivot rod, and the rear
discharge door must rest firmly on top of the
grass catcher.
Grass Catcher
Frame
Insert frame
into bag
Grass
Plastic
Channel
Grass Catcher
Assembly
Complete
Bag
Rear Discharge
Door
Grass
Catcher