22
After replacing the drive belts, adjust the drive
pedal on your tractor as follows:
1.
Locate the speed control assembly on the
underside of the steering support bracket. See
Figure 16.
2.
Remove both hairpin clips from the pin which is
fastened to the speed control assembly (be careful
not to lose the small flat washers found on the pin).
See Figure 16.
3.
Remove the drive pedal return spring.
4.
Using two 9/16" wrenches, remove the pin from the
speed control assembly. See Figure 16.
5.
Thread the idler adjustment rod inward or outward
to lengthen or shorten the travel of the double-idler
bracket until proper adjustment is achieved.
6.
Reassemble by following the above steps in
reverse order.
Off-Season Storage
•
Clean and lubricate the tractor as instructed on page 15 before storing for an extended period.
•
Follow instructions in the Seasonal Storage section of the White Outdoor Engine Operator’s Manual for proper
engine care prior to storing your tractor.
•
It is not necessary to remove the battery from the tractor for storage. However, clean the top fo the battery and
make sure it has full charge. Disconnect the negative terminal of the battery before storing the tractor.
NOTE: Recharge the battery before returning it to service after storage. Even if the tractors starts, the engine
charging system may not bring the battery upto a full charge, unless it is recharged.
Attachments & Accessories
The following attachments and accessories are available for Lawn Tractor Model LT-1500. See your local White
Outdoor dealer for information regarding price and availability.
WARNING:
Never store the machine or fuel container indoors where there is an open flame, spark or
pilot light such as on water heater, furnace, clothes dryer or other gas appliance.
WARNING:
Drain fuel only into an approved container outdoors, away from an open flame. Allow engine
to cool. Extinguish cigarettes, cigars, pipes, and other sources of ignition prior to draining fuel.
MODEL
DESCRIPTION
190-116
Mulch Kit
190-601
Twin Bagger Grass Collector
190-603
Grille Guard (mounts on front of tractor)
190-604
Yard-Mate™ Storage Container/Toolbox (mounts on rear of tractor)
190-607
Tractor Sunshade
190-822
46-inch Front Dozer Blade
190-823
42-inch Two-stage Snow Thrower
Speed Control
Assembly
Hairpin
Clips
Idler
Adj. Rod
Pin
AutoDrive
™
Pedal
Return Spring
Place Wrenches Here
Neutral
Return
Bracket
Figure 16
