FANMASTER HEATER
INFORMATION SHEET
General Information
The Fanmaster is an industrial air heater specifically designed for use in well ventilated indoor areas. The unit
runs on a 8.5kg propane gas cylinder.
Operating Instructions
TO START AND USE
1.
Plug in the mains lead to a wall socket.
2.
Press the ON-OFF switch on. Let the motor fan run at least 230 seconds to check if the fan works properly
and/or to purge any fuel gas left from the last use.
3.
With the hose attached to the gas inlet open the gas valve on the cylinder slowly. Be sure there is no gas
leakage.
4.
Push in and hold the safety start valve button. Push ignition button repeatedly until the burner lights. If
the heater does not light within 10 seconds, wait a minimum of 3 minutes before retrying the correct
ignition circuit.
5.
After the burner lights, keep the safety start valve button depressed for at least 5 seconds then slowly
release and the heater will continue to operate.
SAFETY
•
Keep area clean and well lit.
•
Keep children and bystanders away whilst operating the heater.
•
Do not expose heaters to rain or wet conditions
•
Do not spray aerosols in the vicinity of the heater.
•
Do not place articles on or against the heater.
•
Not for domestic use.
•
Use ONLY in well ventilated areas.
•
Gas cylinder to be place on the side of the heater unit, NOT in front or behind.
•
Be sure that the heater is only used with the correct ventilation. Make sure that no object may
obstruct the fan air intake.
