WARNING: The appliance must not be supplied through an
external switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by a utility
.
ADDITIONAL INFORMATION
Many outlets sell “universal” tumble dryer accessories. These may not fit satisfactorily and could impair the
efficient operation of your tumble dryer and may even cause air-flow restrictions not covered by our guarantee.
Crosslee always obtains test house approval for dryer accessories so use this order form to obtain genuine authentic
accessories.
INSTALLATION
Position the tumble dryer so that the plug remains accessible after installation. Do not block the vent at the side of
the dryer, as this will impair the working of the machine. This appliance must not be installed behind a lockable
door, a sliding door or a door with hinges on the opposite side to that of the tumble dryer.
TUMBLE DRYER VENTING
When using a vent hose, remember the following points:
The vent hose must be at least 10cm (4 ins) in diameter.
No more than three right-angled bends should be allowed when positioning the vent hose.
Do not distort or constrict the vent hose as this will reduce the airflow.
When drying, the vent hose must always be extended to an open door or window.
The vent hose must not be shared with other appliances, for example, a cooker hood outlet.
Note: Do not obstruct or add a mesh to the vent hose outlet during use and ensure that it cannot be blocked or bent
sharply which may obstruct the airflow.
It is recommended that the interior of the hose be periodically inspected and cleaned if necessary.
FINAL INSTALLATION
Your tumble dryer is supplied with a vent hose and a wall mounting
kit.
When mounting your tumble dryer to the wall, please follow the
instructions provided in the wall mounting kit.
A vent hose allows you to direct the warm, damp air expelled from
the rear of the dryer to an open door or window.
The best solution is to make a permanent connection through either
a wall or a window. This is particularly recommended for small,
cool rooms and a kit for this purpose is available as an accessory.
Place the filter in its operating position as shown in
the diagram.
Remove any dust by wiping the drum and door with
a damp cloth. Any initial smell of burning will be
caused by dust on the heater and will quickly
disappear.
