Documentation bag
:
•
Wall mount H.E. owner’s manual
•
R-134a H.E. split system warranty checklist
•
Evaporator unit installation template
Please leave the unit in its original box until you are ready for installation. This will allow you to move the product safely without
damaging it. When you are ready to remove the product from the box, refer to the installation instructions.
TIP:
Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
(1) Mini Split evaporator unit
Condensing Unit Box:
Evaporator Unit Box:
RECEIVING & INSPECTING THE SYSTEM
Upon receiving your unit:
•
Use caution when lifting and check package for damage.
•
Lift only at the designated hand-hold locations on the shipping container, or fully support the unit from underneath. A
shipment may include one or more boxes containing accessories.
•
Before opening the container, inspect the packaging for any obvious signs of damage or mishandling.
•
Write any discrepancy or visual damage on the bill of lading before signing.
•
Allow the condensing unit to sit for 24 hours prior to start-up. The condensing unit can be placed in the installation
location, piped and evacuated during this time.
•
Review the packing slip to verify contents
•
Check the model number to ensure it is correct.
•
Check that all factory options ordered are listed.
If any items listed on the packing slip do not match your order information,
contact Customer Service immediately.
Check all shipped boxes for the following contents:
Accessory kit bag
:
•
Evaporator installation hardware bag
(KDT and 24V unit)
KDT unit only
•
KDT Plus hardware bag
•
Retractable bottle probe
•
KDT Plus display cable (50 feet)
•
KDT Plus wall mount bracket assembly
•
KDT Plus flush mount bracket assembly
•
KDT Plus display assembly
•
Flush mount template
KDT Plus hardware bag
:
Evaporator installation hardware bag
:
(1) Condensing unit
•
(2) 1/2” x 1/2”
nylon bar
bed fitting
•
(1) 1/2”
barbed tee
•
(1) Double-D strain relief
•
(4) 3/4”
adhesive cable tie mounts
•
(2) Small cable ties
•
(4) #8 x 13/4”
hex-head screws
•
(1) 11/16" OD Grommet
•
(2) ½” nylon hole plugs
•
(4) #6 x 1” PHP zinc Type A screws
•
(4) 8-10 x 7/8" Plastic Screw Anchor
Page 7
08/04/21
