www.whisperkool.com | Page 3
Receiving and Inspecting the System
•
Inspect the packaging for any obvious signs of damage or mishandling before opening the container.
•
Note any discrepancies or visual damage on the Bill of Lading before signing.
Review the Packing Slip to Verify Contents
•
Check the model number to ensure it is correct.
•
Check that all factory options ordered are listed.
If any items listed on the packing slip do not match your order information,
contact WhisperKOOL Customer Service immediately.
Before You Start
1. Inspect the Kit before installation.
If damage is found, please contact your distributor or WhisperKOOL
Customer Service at 1-800-343-9463.
2. Verify that you have received all of the items on the “Components Provided” list below and that the Kit
corresponds to your specific WhisperKOOL cooling system.
3. The system is intended
for use in properly designed and constructed wine cellars.
Hire a professional wine
storage consultant with a valid contractor’s license to build your wine cellar.
4. WhisperKOOL requires that all Systems and Cold Weather Start Kit Kits be installed by a certified HVAC-R technician only.
5. The system is intended
for use in properly designed and constructed wine cellars.
Hire a professional wine
storage consultant with a valid contractor’s license to build your wine cellar.
6. Warranty is not active until a Warranty Checklist has been received, reviewed, and approved.
RECEIVING & INSPECTING THE SYSTEM
After verifying that you have received all of the correct components for your specific system, please keep the Cold
Weather Start Kit in its original box until you are ready for installation. This will allow you to move the product safely
without damaging it. When you are ready to remove the product from the box, refer to the installation instructions.
TIP:
Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
Condensing Unit Components Provided:
•
(1) Cold Weather Start Kit Electrical Box
Assembly
•
(1) Silicone Heater Assembly
•
(1) Thermal Switch Assembly
•
(1) H2 Assembly
•
(1) Paper Template
•
(2) Hose Clamps
•
(2) Yellow Female Disconnects
•
(1) Red Female Disconnect
•
(2) ½” Hex Head Self Taping Screws
•
(20) Zip Ties
•
(1) Bag of Thermal Paste
Evaporator Unit Components Provided:
•
(4) Lever Connectors
•
(1) 120v/24v Transformers (with double
sided tape on bottom edge for mounting)
•
(5) Zip Ties (3 for install and 2 additional)
•
Platinum Split/WM & FD Evaporator Unit
Cold Weather Start Kit Field Installation
Instructions
Components Needed (Not Included):
•
2 Wire T-Stat Wire 18-20 AWG
(
Note:
Enough to route from evaporator
unit to condensing unit)
Tools Needed:
•
#1 Philips Head Screw Driver
•
#2 Philips Head Screw Driver
•
5/16” Nut Driver
•
1/4” Nut Driver
•
Drill
•
Wire Cutters
•
Wire Strippers
•
Crimpers
•
Needle Nose Pliers
•
Utility Knife
