CONTROL PANEL
INSTALLATION
1.Location
2.Drain Hose
3.Inlet Hose
4.Electrical Connection
Place the machine on a flat/level surface, well-
ventilated area but away from direct sunlight or
any other heat source, conveniently close to
an electric outlet and near the drainage facility
(This could be a drain pipe, sink or bathroom).
Suitable for the down-drain type:
Drop the drain hose to a outfall ditch.
Suitable for the up-drain type:
Hang the drain hose over a drain outlet or
over the side of a bath or sink, not higher than
1.2 metres above floor level.
4.Open the Water Tap and fill the Wash Tub with
water up to 3 cm below the Water Level Mark.
5.Close the Water Tap.
6.Add a suitable amount of washing machine
detergent in the Wash Tub(Refer to the proper
amount of detergent as specified/directed by
the detergent's manufacturer).
7.Put the clothes one by one into the Wash Tub
and arrange them evenly.
8.Set the Wash Timer to the desired time or you
may refer to the table below for good washing
result.
9.Your Washing Machine will then operate as per
selected time and mode on the Wash Selector.
Connect one end of the Inlet Hose to a Water
Tap. Place the other end of the Hose into the
Inlet.
Turn both Timers (Wash and Spin) to "OFF"
position and insert the plug into an outlet.
1.Open the Wash Tub cover.
2.Insert the plug into an outlet.
3.Turn the Wash Selector to Normal, Strong.It
will depend on the type of fabric and degree of
dirt/soiled.
WASH TIME TABLE
TYPE OF
FABRIC
NORMAL
Normal Soiled
Clothes
3 - 9 mins.
HEAVY
Work
Clothes
10 - 15 mins.
WASH
PROGRAM
WASH
TIME
WASH
WATER INLET
WATER INLET
Whitemagic Washer
XWT-608
W
ASH TIMER
12
0
15
3
6
9
SPIN TIMER
1
5
0
4
3
2
SELECTOR
NORMAL
DRAIN
HEAVY
