background image

S

u

b

je

ct

to

ch

a

n

g

e

-

P

ri

n

te

d

in

It

a

ly

0

4

/1

1

-

©

C

o

p

yr

ig

h

t

W

h

ir

lp

o

o

l

E

u

ro

p

e

s.

r.

l.

2

0

1

1

.

A

ll

ri

g

h

ts

re

se

rv

e

d

Dosing Aid - DAILY USE

IMPORTANT NOTES

• You have to set any options and the start delay before you start the wash programme. That is, before you press the “Start (Pause)” button

for the first time.

• If “Dosing Aid” is selected and you want to add more laundry after you have pressed the “Start (Pause)” button for the first time, proceed

as follows:
- press and hold the “Reset/Drain” button for a few seconds; the display shows the default setting of the programme.
- Wait until the door unlocks (this can take more than a minute).
- Now add your laundry and go on following the procedure as described above ("Daily Use") to get the recommended detergent quantity

displayed.

• When “Dosing Aid” is selected, you have to add the detergent into the dispenser. This also applies if you have set a start delay. You cannot

add the detergent directly to the drum using a dosing cup because the door will be locked while the dosing amount is displayed.

• If “Dosing Aid” is selected and you want to reset everything after you have pressed the “Start (Pause)” button for the first time, proceed

as follows:
- press and hold the “Reset/Drain” button for a few seconds; the display goes back to the initial state. It can take more than a minute until

the door unlocks.

• The duration of programmes with small maximum loads (like “Delicates”, “Wool/Handwash” etc. - see in separate Programme Chart) is

NOT updated according to the amount of laundry added.

• The real programme duration can differ from the time indicated on the display even after the wash load has been identified. This is

because it can be influenced by factors like reduced inlet water temperature, which leads to a longer heating time. Note also that
whenever the programme duration is recalculated, the display shows an animation.

• If you load the drum with laundry which is already wet, do not use the full amount of detergent suggested by the “Dosing Aid” function -

only use 2/3 of the recommended amount.

• The minimum wash load the “Dosing Aid” will identify is 2 kg, even for smaller loads below 2 kg.

5019 106 01494

GB

Start the wash process.

Add the recommended detergent amount to
the dispenser.

After approximately ten seconds the washing
machine suggests the recommended
detergent amount.

Select “Dosing Aid” and start the washing
machine.

Press the “Dosing Aid” button.

The corresponding symbol appears on the
display.

Press “Start (Pause)”. The door locks. The

drum gently moves for about 10 seconds
while the wash load is detected. On the
display an animation is shown.

Note that for Wool and Delicates
programmes the drum will move more gently.

Load the washing
machine with laundry.

Select the desired
programme. Add any
options, and set a start delay
if desired.

The recommended detergent amount in

ml appears on the display.

If you have selected the option “Prewash”,

the display will alternately show the
detergent amount for the prewash chamber
(marked with “I”) and for the main wash
chamber (marked with “II”) of the detergent
dispenser.

Pour the recommended detergent amount

in the appropiate chamber of the dispenser
now.

Prewash

Mainwash

Press the “Start (Pause)” button again.

The washing machine recalculates the

programme duration according to the
detected wash load while the display shows
an animation.

The new wash time is displayed

and the

wash programme starts automatically.

Summary of Contents for WWCR 9230 S

Page 1: ...ues should be adjusted as to match the dosing recommendation reported on the package of the detergent s that you intend to use for each specific group A Check First Check on the package of your generic detergent which dosing amount is recommended for medium water hardness or medium soft and medium soil level or medium light Please use this value when you reach step 3 of the procedure described in ...

Page 2: ...e saved dosing values because you changed the type of detergent you use for example proceed as described above the previously saved dosing value will be replaced by the new one for the programme group you selected Press and hold the Dosing Aid button for a few seconds The bottle symbol on the display lights up and the preset detergent dosing value appears on the display Compare the preset value in...

Page 3: ...ur water hardness settings The water hardness of your washing machine by default is set to SOFT If your local water hardness is medium or hard you must adapt the water hardness of the washing machine as described below Turn on the machine by rotating the knob on any programme Press and hold Dosing Aid and buttons simultaneously for a few seconds A horizontal bar appears on the display This is the ...

Page 4: ...ash load has been identified This is because it can be influenced by factors like reduced inlet water temperature which leads to a longer heating time Note also that whenever the programme duration is recalculated the display shows an animation If you load the drum with laundry which is already wet do not use the full amount of detergent suggested by the Dosing Aid function only use 2 3 of the rec...

Reviews: