19
AFTER SALES SERVICE
Before contacting After Sales Service:
1. See if you can solve the problem yourself with
the help of the Troubleshooting guide.
2. Switch the appliance on again to see if the
problem has been solved. If it has not,
disconnect the appliance from the power
supply and wait for about an hour before
switching on again.
3. If the problem persists after this course of
action, contact After-sales Service.
Specify:
•the nature of the fault,
•the model,
•the Service number (the number after the
word SERVICE on the rating plate on the
inside of the appliance),
•your full address,
•your telephone number and area code.
Note:
The direction of door opening can be changed.
If this operation is performed by After-sales
Service it is not covered by the warranty.
The door cannot be reversed on models with
front handle.
INSTALLATION
• Install the freezer away from heat sources. Installation in a hot
environment, direct exposure to the sun or installation near
heat sources (heaters, radiators, cookers) will increase power
consumption and should therefore be avoided.
• If this is not possible, the following minimum distances must
be respected:
• 30 cm from coal or paraffin stoves;
• 3 cm from electric and/or gas stoves.
• Install the appliance in a dry, well-ventilated place.
• Clean the interior (see “care and maintenance”).
• Fit the accessories supplied (Fig. 1 and 2).
Electrical connection
• Electrical connections must be made in accordance
with local regulations.
• Voltage and power consumption are indicated on the rating
plate inside the appliance.
•
Regulations require that the
appliance is earthed.
The Manufacturer declines all liabilities for injury to
persons or animals or damage to property resulting
from failure to observe these regulations.
• If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
• Do not use extension leads or adapters.
Disconnecting the appliance
Electrical disconnection must be possible either by unplugging
the appliance or by means of a double-pole switch located upline
from the socket.
Fig. 1
Fig. 2
30302004GB.fm Page 19 Wednesday, March 8, 2006 3:49 PM
