3
Electrical Requirements
Observe all governing codes and ordinances.
Required:
■
A 120-volt, 60 Hz, AC-only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Recommended:
■
A time-delay fuse or time-delay circuit breaker.
■
A separate circuit serving only this microwave oven.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
GROUNDING INSTRUCTIONS
SAVE THESE INSTRUCTIONS
■
For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
This device complies with Part 18 of the FCC Rules.
OPERATING YOUR MICROWAVE OVEN
Settings
Clock
The clock is a 12-hour (12:00-11:59) clock. Touch CLOCK, enter
time, then touch CLOCK or the Start control.
Timer
With the microwave oven in Standby mode, touch the Timer
control, enter time, then touch the Timer control or the Start
control. Cook functions may be entered while the Timer is
counting down. To cancel timer, touch Timer control while the
Timer countdown is active in the display.
Vent Fan
Press the Vent Fan keypad once for High setting. You may press
this keypad repeatedly and choose a different speed. There
are three available speeds HIGH(“HI”)--->MEDIUM(“H-L”)---
>LOW(“LO”)--->OFF. Choose the speed you want.
To keep the microwave oven from overheating, the auto hood fan
will automatically turn on at high speed if the temperature from the
range or cooktop below the microwave oven gets too hot. When
this occurs, the hood fan cannot be turned off.
Vent Light
Pressing Vent Light keypad adjusts the vent light setting among
HIGH(“HI”) -> LOW(“LO”) -> OFF.
Control Lock
Activate to avoid unintended start. Touch and hold the Cancel
keypad for about 3 seconds until 2 tones sound and the
CONTROL LOCKED
appears in the display. When locked,
touching any button on the keyboard (except for the hood control
buttons and Cancel) will not work. Repeat to unlock control.
Tones
Open door, press and hold number keypad “4” for 5 seconds to
disable button tones. Repeat to turn buttons tones back on. End
of cycle & timer tones will still be active.
Demo Mode
Activate to practice using the control without actually turning on
the magnetron.
To activate
:
1.
Open door, press and hold number keypad “3” for 5 seconds,
“d” icon lights up in the display.
2.
Press the start button within 5 seconds to turn demo mode on.
3.
“dOn_” icon lights up in the display.
Note:
If start button wasn’t pressed within 5 seconds, return to
idle normal mode.
To deactivate:
R
epeat the procedure as activation during an idle state clock /
standby. Once start is pressed, deactivate demo mode, display
“dOff” for 5 seconds and return to normal operation.
Standby Power Mode
When no functions are working (12-hour clock is displayed or if the
clock has not been set), oven will switch to Standby Power mode
and dim the display brightness after
2
minutes. Press any button
or open/close the door, and then display will return to the normal
brightness.
Turntable
For best cooking results, do not operate the microwave oven
without having the turntable in place. Turntable may be turned off
for manual cooking only.
