6
AIR PURIFIER CARE
Cleaning
1. Press POWER to turn off the air purifier.
2. Unplug air purifier or disconnect power.
3. Place fingers on the front release tabs. Gently push the tabs
in and pull the front grille forward to remove it.
4. Remove both filters and set aside. Do not try to wash and
reuse either the HEPA filter or the pre-filter.
5. Clean the air purifier with a soft, damp cloth.
6. Gently wash the front grille in soapy water.
NOTE: The grille is not dishwasher safe.
7. Reassemble the filters as shown in the previous illustration.
8. Place the top tabs of the front grille into the top slots in the air
purifier. Gently slide the grille forward and down into the
bottom slots until the grille locks into place.
9. Plug in air purifier or reconnect power.
10. Press POWER to turn on the air purifier.
Filter Replacement
NOTE: The filter indicator lights will flash when it is time to
replace either the pre-filter or the HEPA filter. For the most
efficient operation of the air purifier, under normal conditions it is
recommended that you replace the pre-filter every 3 months and
the HEPA filter every year. See “Replacement Filters” in the
“Assistance or Service” section.
1. Press POWER to turn off the air purifier.
2. Unplug air purifier or disconnect power.
3. Place fingers on the front release tabs. Gently push the tabs
in and pull the front grille forward to remove it.
4. Remove and replace the indicated filter. Install the new HEPA
filter in the same direction shown by the arrow located on the
filter frame. Install the new pre-filter by placing it on the tabs.
NOTE: Do not try to wash and reuse either the HEPA filter or
the pre-filter.
5. Place the top tabs of the front grille into the top slots in the air
purifier. Gently slide the grille forward and down into the
bottom slots until the grille locks into place.
6. Plug in air purifier or reconnect power.
7. Press POWER to turn on the air purifier.
8. To reset the HEPA filter status, press the Filter Reset button
1 time. On the LCD display, the HEPA filter status light will
flash. Press the Filter Reset button again and hold for
5 seconds. The HEPA filter timer will reset.
9. To reset the pre-filter status, press the Filter Reset button
2 times. On the LCD display, the pre-filter status light will
flash. Press the Filter Reset button again and hold for
5 seconds. The pre-filter timer will reset.
NOTES:
■
Pressing the Filter Reset button before either filter
indicator light flashes will not reset the filter timer.
■
Use of a non-Whirlpool filter or failure to replace the filter
regularly will invalidate this warranty.
A. Release tabs
B. Control panel
C. Mainframe assembly
D. Bottom slot
E. HEPA filter
F. Pre-filter
G. Front grille
C
D
E
G
A
A
B
F
