Whirlpool WGD94HEXL, Use & Care Manual

Page: 12 / 40

12
ADDITIONAL FEATURES
2. Align the two hooks on the front of the drying rack with
the holes in the dryer door opening and press down fully
into holes. Rest the rear support on the dryer back ledge.
USING THE DRYING RACK
To obtain a drying rack for your dryer, follow the instructions
included in your dryer drum. Remove and discard any
packing material before use.
Use the Drying Rack for items that you do not want to
tumble dry, such as sweaters and tennis shoes. When you
use the drying rack, the drum continues to turn, but the rack
remains stationary.
The drying rack is intended for use with the Manual Dry/
Timed Dry cycles only. The drying rack cannot be used
with Automatic cycles.
To use the drying rack:
IMPORTANT: Do not remove the lint screen.
1.
Open dryer door.
3.
Place wet items on top of the drying rack. Allow space
around items for air to circulate. The drying rack does
not move, but the drum will rotate; be sure to leave
adequate clearance between items and the inside of
the dryer drum. Make sure items do not hang over the
edges or between drying rack grille.
4. Close the door.
5.
Select a Timed Dry/Air Only, or Low Temperature cycle.
Items containing foam, rubber, or plastic must be dried
on a clothesline or by using the Air Only setting.
6. When the cycle is selected, the Estimated Time
Remaining display shows the default time. You can
change the actual time in the cycle by increasing or
decreasing the cycle time.
7. Start the dryer.
NOTE: Check the lint screen and remove any lint
accumulated from items dried on the drying rack
after the cycle is finished.
CYCLE STATUS INDICATORS
Temperature
Cycle Signal Dryness Level Garment #
for auto cycles for refresh cycles
Air Only
Extra Low
Medium
Low
High
Less Dry
Normal Dry
More Dry
6 - 7
8 - 9
2 - 3
1
4 - 5
Soft
Off
Loud
Wrinkle
Shield
Done Wet Damp Cool
Down
Steam Static
Reduce
Check Lint Screen Sensing
Estimated Time Remaining
Timed Dry Adjust
The Cycle Status Indicators show the progress of a cycle.
Check Lint Screen
The Check Lint Screen indicator will light when the drying
cycle is complete as a reminder to clean the lint screen.
Sensing
The Sensing indicator will light during Eco Auto Cycles to
indicate that the moisture sensor on the dryer is operating.
This indicator will not light during Manual Cycles or options
such as Wrinkle Shield
™
.
Wet
The load is still wet and/or the cycle just started.
Damp
This indicator shows that the load is partially dried and items
that you may wish to hang up or iron while still damp may
removed.
Cool Down
The dryer has finished drying with heat, and is now tumbling
the load without heat to cool it down and reduce wrinkling.
Steam (on some models)
This indicator will light when the Steam function is active.
NOTE:
Steam is not available on all models or on all cycles.
Static Reduce (on some models)
This indicator will light when the Static Reduce function is
active.
NOTE: Static Reduce is not available on all models or on
all cycles.
Done
This will indicate that the selected cycle has ended and the
load may be removed from the dryer. If the Wrinkle Shield
option has been selected, the dryer may continue to tumble
the load, even if the Done indicator is lit.
Wrinkle Shield
™
This indicator will light if the Wrinkle Shield option has been
selected and is running. The dryer will continue to tumble the
load for up to 150 minutes after the cycle has ended.
11-cycle model shown