16
Oven Light
The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1.
Unplug range or disconnect power.
2.
Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3.
Turn bulb counterclockwise to remove from socket.
4.
Replace bulb, then bulb cover by turning clockwise.
5.
Plug in range or reconnect power.
TROUBLESHOOTING
First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call, refer
to the warranty page in this manual and scan the code there with your mobile device, or visit
http://www.whirlpool.com/product_help
.
Contact us by mail with any questions or concerns at the address below:
In the U.S.A.:
Whirlpool Brand Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
Operation
PROBLEM
POSSIBLE CAUSES
SOLUTIONS
Nothing will operate
Power supply cord is unplugged.
Plug into a grounded outlet.
Household fuse is blown or a
circuit breaker is tripped.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Range is in Sabbath Mode.
See “Sabbath Mode” section.
Cooktop will not operate
The control knob is set
incorrectly.
Push in knob before turning to a setting.
The range is in Demo Mode.
Demo Mode will deactivate the Warm Zone element. See
“Demo Mode” in the “Electronic Oven Controls” section.
Excessive heat around
cookware on cooktop
Cookware that is not the proper
size.
Use cookware about the same size as the surface cooking
area, element or surface burner. Cookware should not extend
more than ½" (1.3 cm) outside the cooking area.
Cooktop cooking results not
what expected
Control knob set to incorrect heat
level.
See “Cooktop Use” section.
Range is not level.
Level the range. See the Installation Instructions.
Oven will not operate
The electronic oven control was
set incorrectly.
See “Electronic Oven Controls” section.
Delay Start was set.
See “Cook Time” section.
The oven control lockout is set.
See the control lock keypad feature in the “Feature Guide”
section.
The range is in Demo Mode.
Demo Mode will deactivate all heating elements. See “Demo
Mode” in the “Electronic Oven Controls” section.
Convection fan not working
Oven door is open.
Close oven door. See “Convection Cooking” section.
Oven temperature too high or
too low
Oven temperature calibration
needs adjustment.
See “Oven Temperature Control” in the “Electronic Oven
Controls” section.
Temperature has been changed
to Fahrenheit or Celsius.
See “Fahrenheit and Celsius” in the “Electronic Oven Controls”
section.
Oven indicator lights flash
Needs service (oven indicator
lights are flashing).
See “Control Display” in the “Electronic Oven Controls”
section. If the indicator light(s) keeps flashing, call for service.
See cover for contact information.
Display shows messages
Power failure (display shows
flashing time).
Clear the display. On some models, reset the clock, if needed.
See “Clock” keypad feature in the “Feature Guide” section.
Error code (display shows letter
followed by number).
Press the CANCEL keypad to clear the display. See “Control
Display” in the “Electronic Oven Controls” section. If it
reappears, call for service. See cover for contact information.
