Whirlpool WET4027EW, Installation Instructions Manual

Page: 17 / 88

17
4-Wire Direct Wire Connection
IMPORTANT: A 4-wire connection is required for mobile
homes and where local codes do not permit 3-wire
connections.
2.
Prepare to connect neutral ground
wire and neutral wire
E
A
B
Remove center terminal block screw (B). Remove neutral
ground wire (E) from external ground conductor screw (A).
Unscrew the removable conduit connector (A) and any
screws from a 3/4" (19 mm) UL listed strain relief (UL marking
on strain relief). Put the threaded section of the strain relief
(C) through the hole below the terminal block opening (B).
Reaching inside the terminal block opening, screw the
removable conduit connector (A) onto the strain relief threads.
A
B
C
1.
Attach direct wire strain relief
Put direct wire cable through the strain relief. The strain
relief should have a tight fi t with the dryer cabinet and be in
a horizontal position. Tighten strain relief screw against the
direct wire cable.
2.
Attach direct wire cable to strain relief
Direct Wire Strain Relief
Direct wire cable must have 5 ft. (1.52 m) of extra length so
washer/dryer may be moved if needed.
Strip 5" (127 mm) of outer covering from end of cable,
leaving bare ground wire at 5" (127 mm). Cut 1
1
/
2
" (38 mm)
from remaining 3 wires. Strip insulation back 1" (25 mm).
Shape ends of wires into hooks.
1"
(25 mm)
5"
(127 mm
)
1.
Prepare your 4-wire cable for direct
connection
Direct Wire Connection
3-wire direct wire connection:
Go to “3-Wire Direct Wire Connection”
on page 18.
4-wire direct wire connection:
Go to “4-Wire Direct Wire Connection”
on this page.
If your wiring looks like this: