12
OPTION SELECTIONS
OPTIONS
CAN BE
SELECTED
WITH
WHAT IT DOES ADDED
TIME TO
CYCLE
ADDED
WATER
GALLONS
(LITERS)
(varies by
model)
Runs dishwasher at a later time. Select a wash
cycle and options. Each time you press the Delay
keypad, it will display the next available delay time.
Press START/RESUME, then close the door firmly.
NOTES:
■
The dishwasher remembers the last delay you
selected. To reset the delay time to something
other than what is displayed, continue to press
the Delay keypad until the desired delay time
is reached.
■
Anytime the door is opened (such as, to add
a dish), the Start/Resume keypad must be
pressed again to resume delay countdown.
Available with
any cycle
Delays start of
a cycle up to
24 hours.
NA
NA
Raises main wash temperature to improve cleaning
for loads containing tough, baked-on food.
Sensor
Heavy
Normal
Soak & Clean
Raises the
main wash
temperature to
135°F (57°C).
0:05 to 0:13
0 to 3.86
(0 to 14.6)
Dries dishes with heat. This option, with the use
of rinse aid, will provide better drying performance.
Plastic items are less likely to deform when loaded
in the top rack. Use Heat Dry for optimum dry
performance. Turn the Heat Dry option off for
air dry.
Extended Dry lengthens the time that Heat Dry
is active. This option with the use of rinse aid will
provide better drying performance.
Sensor
Heavy
Normal
Soak & Clean
Uses heating
element to speed
drying times.
Heat Dry option
defaults to on
when any cycle is
selected, except
for 1-Hour Wash.
0:08 to 0:46
0
(location of
“Sanitized”
indicator varies
by model)
Sanitizes dishes and glassware in accordance
with NSF International NSF/ANSI Standard 184
for Residential Dishwashers. Certified residential
dishwashers are not intended for licensed food
establishments. Only sanitizing cycles have been
designed to meet the requirements of the NSF/
ANSI 184 performance standard for soil removal
and for sanitization efficacy. There is no intention,
either directly or indirectly, that all cycles on a
NSF/ANSI 184 certified dishwasher meet the NSF/
ANSI 184 performance standard for soil removal
and for sanitization efficacy.
At end of the cycle, the “Sanitized” indicator will
glow. If your load did not properly sanitize, the
indicator will flash at the end of the cycle. This can
happen if the cycle is interrupted or if the water
does not reach the required temperature. The light
goes off when you open and close the door or
press CANCEL.
Sensor
Heavy
Normal
Raises the
main wash
temperature to
135°F (57°C) and
the final rinse
temperature to
156°F (69°C).
0:05 to 1:06
0 to 3.86
(0 to 14.6)
Avoids unintended use of dishwasher between cycles, or cycle and option changes during a cycle.
To turn on Lock, press and hold CONTROL LOCK for 3 seconds. Control Lock light will stay on for a short time,
indicating that it is activated and all keypads are disabled. If you press any keypad while your dishwasher is locked,
light flashes 3 times. Dishwasher door can still be opened/closed while the controls are locked.
To turn off Lock, press and hold CONTROL LOCK for 3 seconds. Light turns off.
