15
PREPARE DISHWASHER
Helpful Tip:
Remove all internal shipping material, drain hose,
installation kit, and handle (if included,) before laying on it’s back,
and not to remove film on the door at this time.
Place cardboard under dishwasher until installed
in cabinet opening to avoid damaging floor covering.
Using two or more people, grasp sides of dishwasher door frame,
and place the dishwasher on its back.
Do not use the door panel as a worktable without first covering
it with a towel to avoid scratching the door panel.
REMOVE ACCESS PANEL AND INSULATION
Using a 5/16" (7.9 mm) nut driver, remove the two screws
attaching access panels to dishwasher. Once the screws are
removed push the access panel toward the top of the project to
unhook it and then remove it.
DISCONNECT AND REMOVE DRIP TRAY
ASSEMBLY
10a.
Remove drip tray assembly
To remove the drip tray assembly, press the snap at each side
of the plastic tray in toward the center of the product and pull
toward yourself. Take caution not to pull too far or too hard as the
float switch wire is still connected at this time.
10b. Remove float switch wire
To remove the float switch wire, gently push the connector latch
tab (1) and then pull the connector (2) out of the housing. The
float itself should not be removed from the tray.
NOTE:
Not to install drip tray until instructed.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
WARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
8.
Put the dishwasher on its back
9.
Remove access panels
10.
Remove
access
panel
Drip tray assembly
1
2
