9
STEP 3
Rinse Aid
SLIDE
IMPORTANT:
Your dishwasher is designed to use rinse aid.
The use of rinse aids greatly improves drying by allowing water
to drain from the dishes after the final rinse. Rinse aid also keeps
water from forming droplets that can dry as spots or streaks.
Filling the dispenser
Full
Add
The dispenser holds 5 oz (150 mL) of rinse
aid. Under most conditions, this will last
1 to 3 months.
NOTE:
Indicator reads correct fill level
when door is completely opened.
1.
Pre
W
ash
OPEN
SLIDE
To add rinse aid, open the
rinse aid dispenser lid by
gently pushing in the center of
the lid with your thumb and
pulling up on the edge.
2.
Pour rinse aid into the
opening until the dispenser
is full. Do not overfill.
3.
Clean up any spilled rinse aid.
Spilled rinse aid can create excessive suds.
4.
Close the dispenser by pushing down gently on the lid.
Rinse Aid Setting
Your rinse aid dispenser is adjustable. For most
water conditions, the factory setting will give
good results. If you have hard water and notice
calcium buildup on your dishware, you may want
to try a higher setting. If you notice foam in your
dishwasher, use a lower setting.
To adjust the setting:
Turn the arrow adjuster to a higher number
to increase the amount of rinse aid.
STEP 4
Select a Cycle (varies by model)
Efficient dishwashers run longer to save water and energy, just
as driving a car slower saves gas. Cycle times may increase or
decrease depending on selections. Estimated cycle times after
calibration are listed in the “Cycles” chart in the “Cycle and
Option Descriptions” section.
Select the desired cycle by pressing a cycle keypad.
Select Options (varies by model)
See the “Options” chart in the “Cycle and Option Descriptions”
section.
You can customize the cycles by selecting the options desired.
STEP 5
Start or Resume a Cycle
■
If needed, run hot water at the sink nearest your dishwasher
until the water is hot. Turn off water.
■
For best dishwashing results, water should be 120ºF (49ºC)
as it enters the dishwasher.
■
Select the wash cycle and options desired.
Within 4 seconds of pressing Start/Resume
you must firmly push the door closed. If
the door is not closed within 4 seconds,
the Start/Resume LED will flash, an audible
tone will be heard, and the cycle will not
start.
■
You can add an item at the beginning of the cycle. Open the
door slowly and add the item. Press START/RESUME and
close the door firmly within 4 seconds. If the door has been
open more than 4 seconds, the LED will flash, a tone will
sound and the dishwasher will not resume unless you press
Start/Resume again.
IMPORTANT:
If the door has been opened after starting a cycle
(even during the Delay Hours option), the Start/Resume keypad
must be pressed again.
