10
CONTROLS AND CYCLE STATUS
Control
Purpose
Comments
To start or resume
a wash cycle.
If the door is opened during a cycle or the power is interrupted, the Start/Resume
LED flashes. The cycle will not resume until Start/Resume is pressed and the door
is closed.
NOTE: Push door firmly closed within 4 seconds of pressing Start/Resume or the
dishwasher will not start. If door is not closed within 4 seconds, the Start/Resume
LED will flash when the door is closed.
To cancel a wash
cycle.
Press and hold CANCEL/DRAIN for 3 seconds. Close the door firmly. The
dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely.
To inform you that
the dishes have
been sanitized.
If you select the Sani Rinse option, when the cycle is finished, the Sanitized
indicator on the control panel glows. If your dishwasher did not properly sanitize
your dishes, the Sanitized indicator flashes at the end of the cycle. This can happen
if the cycle is interrupted or if water could not be heated to required temperature.
The indicator goes off when you open and close door or press Cancel/Drain.
Dishwasher Features
Silverware Basket
Splittable Silverware Basket
The splittable silverware basket can be separated and placed in
various locations in the lower rack. Load flatware and utensils into
both sections or just one, depending on your load.
To split the basket:
Hold the basket firmly along the sides.
Unlock the baskets.
Silverware basket lids:
Use silverware basket lids to provide
optimal spacing and best cleaning
performance.
Mix silverware types to keep them
separated. Load knives down, forks up,
and alternate spoons, for best cleaning
results.
NOTE: If your silverware does not fit into the designated slots,
push tabs inward on either end and lift lid off of the silverware
baskets.
Cup Shelves
Fold down the extra shelf on the top rack
to hold additional cups, stemware, or long
items such as utensils and spatulas. For
best results on cups, stagger the spacing
so that the cups on the shelf are not
directly above the cups below.
EZ-2-Lift™ Top Rack Adjuster
You can raise or lower the top rack to fit tall items in either the top
or bottom rack. Adjusters are located on each side of the top rack.
To raise the rack:
Press both rack adjuster
thumb levers and lift the rack
until it is in the up position
and level.
To lower the rack:
Press both rack adjuster
thumb levers and slide the
rack to its down position
and level.
NOTE: The top rack must
be level.
Removable Top Rack
The removable top rack allows you to wash larger items such
as pots, roasters, and cookie sheets in the bottom rack.
IMPORTANT: Remove dishes prior to removing the top rack
from the dishwasher.
To remove the rack:
1. To gain access to the track stops, pull the upper rack forward
about halfway out of the tub.
2. Press on the edge of the ridged area on the track stop while
tipping the track stop toward the center of the dishwasher.
This action releases a small retaining tab that locks the track
stop to the track (see Track stop - left).
NOTE: It is helpful to use two hands. Take special note of the
orientation of the track stops.
Track stop - left
3. With the retaining tab released, pull the track stop straight
toward the opposite track to remove it.
4. After removing both track stops, gently pull the top rack out
of the tracks by rolling it toward you.
